home     galleries     movies    red.red's corner     the incompleat self-spanker     spankings      caning machine     vote

Precision Caning Machine - V2.0
The 1 mm Cane
first tried during the 04/23/06 spanking

As usual, right click on the link and select "Save Link Target As" to download them to your computer.
the thumbnails are chosen so that the implements are clearly seen - they do not show the maximum motion caused
The .MPG files do.

	Three Rods - 6.8MB mpg file a 1 inch diameter pine rod, a 5/8" diameter phenolic rod and a 3/4" (18 mm) fiberglass rod are used the fiberglass rod has been milled so that it also has a 9 mm side as shown at right this is a very heavy, deep impact rod, even after machining only the 18 mm side is applied in this .MPG file
	Fiberglass Rod 9 mm side - 14.7MB mpg file the machine has few vertical positions that are easily selectable in this version these are approximately 1 inch apart and quite accurate except for my body motion
	6 mm / 1 mm oak rod - 20.4MB mpg file the pictorials at right are not arrows, they show the cross-section of each rod / bar the surface to be struck is to the left of each pictorial the apparent "sharp edge" of the lower pictorial is actually rounded to a 1mm radius
	a "universal cane holder" was made for this session and thoroughly tried it is very kind to all canes - it has no sharp edges in the holding clamp to fatigue or break the cane however, the weight penalty for this design was very high and there was significant loss of velocity some .MPG files of this caning will be posted as soon as I can find the time a thorough redesign of the positioning system and the cane holders is now underway